Yes Shed Plan

Cabriole Legs Take Two

Ok, so I was not really pleased with my first cabriole leg design, so I decided to have another go at it. Using the template from my previous post I prepared another pine blank from a couple 2x4".

From Coffee Table

After it was dry I took it down to the final dimensions of 20" long by 2.75" square. I then traced the pattern onto the two adjacent sides.

From Coffee Table

From Coffee Table

Then it was over to the bandsaw to cut it out. I made the first cut, saving the piece and taped it back on to provide support while cutting the second piece; simple blue tape works fine.

From Coffee Table

Finally, I had my ruffed out leg. You will notice in the picture below that the post is still the 2.75" square blank size; this is so I can put it on the lathe to turn the foot.

From Coffee Table

Before I turn the foot though, I need to relieve some material on the heel so I will not hit it while on the lathe. Here I have marked out the area I need to relieve; I will do that with a spokeshave.

From Coffee Table

Now to the lathe to turn the foot. All I want to do here is round out the bottom of the foot and define the pad. You can see in the picture below that I have drawn a line to where I want the pad to be, its a little big on this one and will be refined on the final version.

From Coffee Table

Finally, after some turning and some work with a combination of the spokeshave and rasp, I have a more "finished" product. Also note that after I was done with turning the foot that I cut the posts back on the bandsaw.

From Coffee Table

From Coffee Table

I posted this over on T-Chisels forum and received some good feedback about rounding the edges a little more and making it with a little more "sweep" instead of being so straight so I need to look into that.